Top Ideas For Concrete Polishing
The polishing industry is one of the industries that have risen up rapidly. The companies that are growing and those that are coming up now are too many in this industry. Still other companies will start as most people are getting into this industry. Quality concrete polishing can be done with the companies that apply the tips contained in this article. Below are the tips that can be applied in concrete polishing.
Determining the surface hardness is the first thing that should be done. This is done by testing its hardness using a concrete hardness tester. This helps in the selection of the abrasives. The tip number nine is the one used for scraping first. Then the scratching is then done in a decreasing order. This continues to a level where the tip cannot do scratching anymore. At this level, the hardness is ok now.
Then the concrete surface is then prepared. Sometimes one can get the coated floors. Then the right equipment is used to remove the coating. The equipment for removing the coating varies with the type of coating. Some floors normally have cracks and holes. The repairing of this holes and cracks should be done first. Then gritting is done with the metal bond tooling to a level and flatness that is appropriate.
The tool marks are then eliminated. This can be done effectively with the use of the transitional tooling. The marks made by the tool can be removed very well with the use of transitional tooling. All the tool marks have to disappear for the tool mark removal process to be considered successful.
Then densifying and hardening of the floor is done with the process of vacuuming. The floor is densified and solidified by the pore and crack filler. Also vacuuming helps in protecting the floor from allowing water penetration and stain creation. However, care should be taken to avoid pooling of the floor by the densifiers. This is because the stains caused by poling can result to the stains that can make polishing hard to do.
Then concrete polishing is done. One is advised to start with the resign band. Then all the dust is removed that is, the space is vacuumed in between the passes. After the final grit level is reached, burnishing is done with the use of a burnishing pad.
Then the last thing that should be done to the floor is protecting it. The protection is done by sealing the floor. Some of the things that the floor is protected from are the grease, oil and any other chemicals. The floor sealer is bet applied with the use of the pump. The floor can be left shining after burnishing is done. Successful concrete polishing can be done with the tips given.